- Is a 3.73 axle ratio good for towing?
- Are 4.10 gears good for highway?
- What is a max tow package?
- How much can a 5.3 v8 tow?
- Is 3.55 or 3.73 gears better?
- How fast can you go with 4.10 gears?
- Are 4.10 and 4.11 gears the same?
- Is 3.08 a good gear ratio for towing?
- Can I tow with a 3.23 gear ratio?
- Is 3.42 or 3.73 better?
- What gear ratio is best for fuel economy?
- Are 3.73 gears good for highway?
- What is the difference between 3.73 and 4.10 gear ratio?
- Is a higher axle ratio better for towing?
- Is a 4.10 gear ratio good for towing?
- Which gear ratio is faster?
- What’s the best gear ratio for 35 inch tires?
Is a 3.73 axle ratio good for towing?
A 3.73 ratio is suitable for regular light towing.
If you plan on towing a fifth-wheel trailer or anything heavier than 5,000 pounds, you should consider a 4.1 axle ratio.
A 4.1 ratio allows a towing vehicle to start moving without as much throttle..
Are 4.10 gears good for highway?
Installing 4.10 gears improves the car’s performance on the track but with negligible effects to the highway driving. … Switching from a gear set of 3.55 or 3.73 to 4.10 gears will affect your gas mileage slightly as your engine will be turning more times to rotate the rear wheels once.
What is a max tow package?
The Max Tow Package This improved towing package includes all the mechanical and electronic features found in the starting towing package, from the engine oil cooler and upgraded stabilizer bar to Pro Trailer Backup Assist and Smart Trailer Tow Connector.
How much can a 5.3 v8 tow?
Its towing capacity is 7,900 pounds. 5.3L V8 Engine: With this available engine, the Chevy Silverado 1500 achieves 355 hp and 383 lb-ft of torque. Towing capacity is elevated to 11,600 pounds. 6.2L V8 Engine: Equipped with this engine, the Chevy Silverado 1500 can tow its maximum of 13,400 pounds (on the RST trim).
Is 3.55 or 3.73 gears better?
3.55 will give you a little better gas mileage on the highway and slightly more highway oriented performance. 3.73 may be better for towing, lower end power (off the line acceleration), and may result in worse gas mileage on the highway.
How fast can you go with 4.10 gears?
On the highway a 4.10 gear will only be about 200 rpms more at around 75 then a 3.73. And with the Automatic you will need all the help you can get. Top Speed of our GT’s should be between 145 and 155 depending on the tune of your chip if you have one.
Are 4.10 and 4.11 gears the same?
Registered. It is just two different ways to come up with something that is basically the same. The only difference is the number of teeth on the ring and pinion gears. One company might use 41 on the ring and 10 on the pinion (4.10), while another might use 37 on the ring gear and 9 on the pinion (4.11).
Is 3.08 a good gear ratio for towing?
Yes, you are exactly right, towing with a 6 speed with 3.08s is still better than towing with a 4 speed and 3.73s. If its a heavy trailer, you will probably never use 5th and 6th gears, but who cares? crank turns to rotate the rear wheels once that counts.
Can I tow with a 3.23 gear ratio?
The Chevy Silverado four-wheel drive crew-cab truck features a standard 3.23 axle gearing. A 9,600-pound tow rating results, which is impressive for the equipped standard axle ratio.
Is 3.42 or 3.73 better?
The 3.42 is fine for towing smaller boats, plus you will get better gas mileage for everyday driving. If I were towing frequently on hilly roads, I might would go for the 3.73 for better gas mileage while towing, but the 3.42 should be fine with a 205.
What gear ratio is best for fuel economy?
The lower the number, the better fuel economy, and the higher the number the more towing power you have, but fuel economy suffers. For instance, a 3:31 gets better fuel economy than a 3:73. On the other hand, a 3:73 or perhaps a 4:10 will tow much more, while fuel economy greatly drops.
Are 3.73 gears good for highway?
Well, if you plan on doing a lot of freeway driving, you don’t want to choose a gear that’s too low for your car because you’ll be going down the freeway at too high of an RPM. … Shorter gears (higher numbers) are much better suited for accelerating, such as 3.55, 3.73, 3.91’s, 4.11’s etc.
What is the difference between 3.73 and 4.10 gear ratio?
Use this rule of thumb: The higher the gear ratio, the easier it is to get the vehicle moving and better accelerating, but lowers top speed. Vice versa, if the gear ratio is lower it has worse acceleration but a higher top speed….WHICH GEAR RATIO IS FOR YOU?3.73 RATIO4.10 RATIOHigher top speedLower top speed3 more rows•May 12, 2020
Is a higher axle ratio better for towing?
If you are constantly towing, the highest axle gear ratio possible is what you’re after. The choice of a numerically higher axle ratio will only knock off about 1 mile per gallon from the truck’s fuel economy. But since pickup truck fuel efficiency is low to begin with, even a 1 mpg reduction is significant.
Is a 4.10 gear ratio good for towing?
FACT: A 4.10 axle ratio is ideal for towing heavy loads in a mix of city and highway driving and when towing on varied or steep grades. A 4.10 axle ratio will provide improved acceleration in stop and go city traffic. … A 4.10 rear axle ratio is ideal for towing larger 5th Wheel or Gooseneck trailers.
Which gear ratio is faster?
The higher the number the better the car will accelerate, but at the expense of high speed cruising. Now for the confusing part of the story. A high numerical gear ratio is called a low gear or low rear end, and vice versa. Low gears give fast acceleration, high gears give better cruising.
What’s the best gear ratio for 35 inch tires?
Depending on the axle, the next lowest ratio from a 4.10:1 is most likely the 4.56:1, which should be selected for towing and performance. Because of the extra weight associated with off-road tires, we usually recommend going with a performance-minded gear ratio for any tire size above 35 inches.